Electric Car Motor

The largest provider of Warp Series DC motors is NetGain Motors, Inc. These motors designed especially for electric cars.

WarP 9 ™ Motor
It is a 9.25″ diameter, series wound DC motor with a double ended shaft.  WarP 9 ™ motor is similar to the ADC 9″ motor, but with several improvements. The com bars are more securely attached to the arbor, so they will be less likely to lift. The drive shaft is bored for a pilot bearing and drilled & tapped for a 5/16 – 18 bolt. The tail shaft also has a 1/4 – 20 bolt hole to mount tach sensors or secure couplers and accessories. Class “H” insulation is used throughout the motor. The drive shaft and tail shaft have standard keyways cut into them. The price is about 1795 $.

WarP 11 ™ Motor
It is a 11.45″ diameter, series wound DC motor with a double ended shaft. WarP 11 ™ motor comes set with advanced timing CCWDE. The com bars are more securely attached to the arbor, so they will be less likely to lift. The drive shaft is bored for a pilot bearing and drilled & tapped for a 5/16 – 18 bolt. The tail shaft also has a 1/4 – 20 bolt hole to mount tach sensors or secure couplers and accessories. Class “H” insulation is used throughout the motor. The drive shaft and tail shaft have standard keyways cut into them. The price is about 2950 $.

WarP 13 ™ Motor
This is a 13.25″ diameter, series wound DC motor with a double ended shaft. This motor can have its fields switched from serial to parallel! The engineers at Warfield Electric said: “This motor is Torque City” when it was dyno tested! The com bars are more securely attached to the arbor, so they will be less likely to lift. The drive shaft is bored for a pilot bearing and drilled & tapped for a 1/2 – 13 bolt. The tail shaft also has a 1/4 – 20 bolt hole to mount tach sensors or secure couplers and accessories. This motor is a “foot-mount” and should not be considered for face mounting due to its weight. Class “H” insulation is used throughout the motor. The drive shaft and tail shaft may be specially designed or use standard keyways or splines. The price is about 4725 $.